Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Everman, TX

Broken Garage Door Spring Repair in Everman, TX

Fast replacement of broken torsion or extension springs, sized to your door's weight. Typical cost $200-$450.

Broken Garage Door Spring Repair is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. Fast replacement of broken torsion or extension springs, sized to your door's weight.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for broken garage door spring repair

  • A loud bang from the garage, like a gunshot
  • A visible gap in the coils of the spring above the door
  • The door feels extremely heavy or won't lift more than a few inches
  • The opener strains, hums or the door reverses right away
  • Cables hanging loose from the drums

What usually causes it

  • Springs reaching the end of their cycle life (usually about 10,000 cycles)
  • Rust on the coils, which adds friction and stress
  • Springs that were the wrong size for the door
  • Cold weather making worn steel more brittle

Safe checks before you call

  • Don't use the opener. It can strip gears or pull the door off track.
  • Don't try to lift the door by hand. Without a working spring it may weigh 130 to 250 pounds or more.
  • Look, but don't touch: a broken torsion spring shows a clear gap in the coils.
  • Keep the door closed and keep children and pets away from it.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our broken garage door spring repair process

  1. Secure the door and safely unwind any remaining spring tension
  2. Weigh and measure the door to size the new springs correctly
  3. Install new springs (we recommend replacing both on a two-spring door)
  4. Wind, set and balance the door so it stays put halfway up
  5. Test the opener's force and auto-reverse settings

Broken Garage Door Spring Repair cost in Everman, TX

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Everman, TX and nearby towns

Humidity in Texas puts a thin layer of rust on spring coils, and that friction wears springs out early. Coated or galvanized springs last noticeably longer here.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Besides Everman (ZIP codes 76134 and 76140), we handle broken garage door spring repair in Forest Hill (3.1 mi), Edgecliff Village (3.6 mi), Kennedale (3.8 mi) and Rendon (4.7 mi). Call (833) 435-8883 to book a visit in Everman.

Broken Garage Door Spring Repair: frequently asked questions

How much does broken garage door spring repair cost in Everman, TX?

Broken Garage Door Spring Repair typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do broken garage door spring repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is broken garage door spring repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Texas or Everman requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Everman, TX

Midland Garage Door Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Chamberlain Opener Gear & Sprocket Replacement

Chamberlain is the retail line of The Chamberlain Group, sold at home centers. It uses the same Security+ 2.0 remote technology and myQ app as LiftMaster, so many accessories work with both brands.

Typical $125-$275

Raynor Weather Seal Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $100-$300

Stanley Opener Gear & Sprocket Replacement

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $125-$275

Holmes Garage Door Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Hörmann Garage Door Panel Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $300-$900

Craftsman Garage Door Opener Repair

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $125-$350

Wall-Mount (Jackshaft) Opener Installation

Side-mounted openers that free up ceiling space and run quietly.

Typical $700-$1,400

Cornell Cookson Rolling Steel Door Repair

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $300-$1,500

Genie Remote & Keypad Programming

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $50-$150

Ryobi Garage Door Opener Installation

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $350-$800

Garaga Garage Door Panel Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $300-$900

Garage door stuck, noisy or broken?

Talk to a garage door technician in Everman, TX now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote